Menu
FIR1300 is the Val6 Series’ Far-Infrared heater. With safer and deeper heat penetration with less intensity, Val6 can be used in a wider range of environments than ever before.
By tuning the frequency of infrared-radiation specifically to our bodies and surroundings, FIR1300 is the most efficient, “people friendly” Val6 ever.
FIR1300 features a closed-flame design that makes the heater suitable for indoor environments, Supplemented with a clean exhaust and low noise design that allows for quiet operation in any environment.
A built-in thermostat keeps the space at the perfect comfortable temperature all the time.
LARGER SURFACE AREA – Compared to traditional VAL6 that uses a radiation disk design, this tube-style radiation surface offers much greater surface area resulting in higher thermal efficiency than other VAL6
CLOSED-FLAME DESIGN – The enclosed burner allows the heater to be used and accepted into a wider range of use-cases as closed flame heaters are regulated differently than traditional, Open-Flame heaters.
SAFETY – The outer surface of the heater stays warm to the touch, reducing the risk of burns from contact with the heater.
CLEAN EXHAUST – Due to the high efficiency of the FIR1300, the exhaust contains undetectable ammounts of Carbon Monoxide. Greatly increasing where VAL6 can be used.
BUILT IN THERMOSTAT – The surrounding temperature can be maintained with the built-in thermostat. An external thermostat can also be attached via a connector to control temperatures that are a distance away.
| Item/Model | FIR1300 |
|---|---|
| Heat Output | 52,000 BTU/hr |
| Fuel | Kerosene or Fuel-Oil no heavier than No.2 (Diesel) |
| Fuel Consumption | 0.32 gallons/hr |
| Tank Capacity | 8 gallons |
| Continuous Operating Time | 21~22 hours |
| Power Source | AC 120V 60Hz |
| Power Consumption | in ignition : 70W in burning : 50W |
| External Dimensions (HxWxD) | 36.2x12.6x45.3 (inch) |
| Safety Devices | Flame monitor, Overheat prevention, Over-Current shorting, Motor overheat prevention, Tip-over switch, Motor Rotation detection |
| Carbon Monoxide Density | 0 ppm |
| Operating Noise Level | 50 dB (A) |
Below are practical applications of how FIR1300 can serve you and your needs.
© 2024 by A1 Infrared Technologies Inc. All rights reserved.
